Got your own idea and want to prepare your own extensions? Our DIY set is the solution! This set contains a massive 36" / 96cm wide weft of hair with 15 metal clips (not attached). This is roughly the same amount as our Full Head Set. You can cut the weft as you want and then simply attach the clips.
Complete with 15 metal clips NOT attached to the wefts complete with silicone tubing for a secure grip.
Set Contents:
One 36" wide weft
15 separate metal clips
Specifications:
Hair Type: 100% Silky Remy Human Hair
Hair Style: Straight
Hair Length: 24” (61cm)
Number of Wefts: 1
Number of Clips: 15
Total Width: 36” (96cm)
Set Weight: 115g (100g of hair)
Application Time: 5 minutes (approx.)
Life: 6 to 12 Months (depending on care and use)
Usage: Can be curled, straightened, tongued, washed & dyed.
HOW TO ATTACH CLIP IN EXTENSIONS
 |
Use your index fingers to make the parting. These partings are referred to (in professional terms) as tracks. |
 |
Always follow the contour of your head.Move your fingers from the front towards the back until they meet in the center of your head. The result is a "U" shaped part. |
 |
If you have long hair, you'll need to get it out of the way so it won't get caught in the clips. Clean, neat parts make a difference. First, it's uncomfortable if you catch loose hairs in the clips. We call these cross-hairs. Second, this isn't safe. That's because it's these cross-hairs that will be pulled out of your head whenever there is any "stress" on these hairs. By stress I mean any pulling on the hair which can happen, as an example, when you lean against the back of your car seat. |
 |
Pop (snap) open the clips on the weft. On the wefts used on the back of your head, the Back Pieces have 3 clips. One at each end and one in the middle. |
 |
To open the clips, put your index fingers behind the clip and your thumbs on the clips. Then simply push your index fingers against the clip and - click - the clip pops open.
To close a clip, just apply a little pressure - click - and it snaps shut. |
 |
 |
It's very important that you place the clips on the hair below the part. This is the natural way your hair grows. We have a saying I'd like you to remember. You can fool Mother Nature but never go against her! For the wefts in the back, start with the middle clip. Capture hair (under the part) and snap shut. |
 |
After doing the middle clip, you can then attach the two end clips. There you are - more hair in just a snap!
Easy To Attach - Clip-In Side Pieces
Side pieces can go on the side, in the back and even on the top of your head. |
| HOW TO REMOVE YOUR HAIR EXTENSIONS |
Simply open the clip by gently pulling backwards until you hear the clip release. Then gently remove the section being careful not to pull your hair. It is suggested to move the placement of your sections slightly every couple of wearing. This will allow the clip to rest in a different area preventing too much stress on your hair.
|
| AFTERCARE INSTRUCTIONS |
- Shampooing should be done only after 4 to 5 uses.
- Gently detangle thoroughly from ends to clips with a pick or wide tooth comb before washing Clip-in Hair Extensions.
- Use a gentle flow of water holding your Hair Extensions by the clip allowing the water to run down the hair shafts (does not scrunch or tangle hair).
- Carefully shampoo with tepid water and moisturizing or detangling shampoo. Do not rub or twist the hair. Gently squeeze shampoo through hair from clips to ends. Rinse thoroughly.
- Gently squeeze out excess water and pat or squeeze dry with towel. Do not roll or rub hair dry in towel.
- Gently detangle again with a pick or wide tooth comb. Start with the ends and work upward to remove any tangles (being careful not to pull too hard).
- Do not brush when wet.
- We recommend you let your Hair Extensions air dry. If you do choose to blow dry, use the low cool setting.
- Store with clips closed to avoid tangling.
|
